10 pairs LSA profile disconnection module

Descriptions

TP-1201-10P LSA profiel disconnection module is used throughout the distribution level, in the main distribution frame (MDF), in the cross connection cabinet (CCC) and in the distribution point (DP) boxes. It is highly reliable and cost-effective wire connection system for modern telecommunications and data networks.

It adopts IDC (Insulation Displacement Connection) technique, which means that no soldering, wire-stripping or the use of screws is necessary, and which clamps the wires at a 45 degree angle, thus dramatically reducing the risk of a poor termination and increasing the wiring productivity. The IDC contact is phosphor bronze, with silver plating.

TP-1201-10P LSA profile disconnection modules use a normally closed two piece contact, with a convenient disconnection feature. By inserting a disconnect plug into a wire pair, you can temporarily or permanently disconnect the circuit. A test cord can be inserted into a pair to test each side of the circuit independently. This greatly accelerates fault identification. The center contact point can also be used for monitoring or overvoltage protection.

Main Features

Insulation Displacement Connection

No Wire-stripping, screw and solder free

Reliable connections

Clear labeling

Flame retardant performance

Modular design and installations

Gas tight connection

Two wires per contact

One push wire insertion

No Wire-stripping, screw and solder free

Only one inexpensive tool required

Schematic Diagram

Schematic Diagram for 10 pairs LSA profile disconnection module

Technical Parameters

Working temperature: -40℃ ~ 80℃

Relative humidity: ≤93%(+40℃)

Appearance: the color of all metal and plastic parts is uniform, without any scratch, rust, crusting and cracks.

The labels are clear and complete.

Insulation resistance: under normal ambient conditions, after high temperature test, low temperature test, temperature varing test and humidity heat test, the insulation resistance between any two independent contacts, and/or between contacts and metal parts ≥ 1000MΩ

Contact resistance between contacts: under normal ambient conditions, the contact resistance between contacts ≤7 mΩ. After high temperature test, low temperature test, temperature varing test and humidity heat test, the increasing resistance ≤3 mΩ And after inserting the connection cord (or test cord) into the module for 200 times, the increasing resistance ≤3 mΩ

Contact resistance between conductor and contact: under normal ambient conditions, the contact resistance between contacts ≤3 mΩ. After high temperature test, low temperature test, temperature varing test and humidity heat test, the increasing resistance ≤2 mΩ. And after terminating for 200 times, the increasing resistance ≤2 mΩ.

Dielectric strength: under normal ambient conditions, after high temperature test, low temperature test, temperature varing test and humidity heat test, the insulation resistance between any two independent contacts, and/or between contacts and metal parts is able to withstand an AC voltage of 1000V (virtual value) at 45Hz~60Hz sinowave for 1 minute, without spark over and flying arc

Gas tight performance: contact touches the conductor at both sides, and thus forming the gas tight area, while the area of gas tight occupies ≥50% of the touched area on each side.

Conductor diameter range: 0.32mm-0.6mm, while insulation ≤ 1.4mm

Pulling strength:≥25N while pulling from the vertical side of the contacts

Flame retardant performance: all plastic parts are flame retardant, reaching grade of UL FV0

Silver plating thickness: 0.5um

Life circle: ≥200 times

Order Data

10 pairs LSA profile disconnection module


Referenced picture for 10 pairs LSA profile disconnection module